Lippage
![](https://surfaceartinc.com/wp-content/uploads/2023/09/Lippage.png)
From choosing a tile to completing the installation, customers and installers need to be aware of how the final project will look once the process is complete. Each tile is a different thickness and a slight variation is to be expected from one tile to the next. In the days before isostatic presses, warpage was more common. Today, many mass-produced tiles have exceedingly little warpage. However, variation and slight imperfections still exist. This is why regulations need to be followed to ensure the job is done well and the customer is satisfied. But what are these regulations? This white page defines the laws of lippage and will equip you with the knowledge that will give your customers a peace of mind when they are selecting their tile.
DEFINING LIPPAGE
In order to understand what is an acceptable variation in the height of adjoining tiles let us first define what lippage is. Variation in the height of adjoining tiles is called lippage. This is defined in the ANSI (American National Standards Institute) standard “Lippage refers to differences in elevation between edges of adjacent tile modules.” The ANSI standard voices the perception of lippage is influenced by many factors such as:
- The allowable thickness variation of the tile modules when judged in accordance with manufacturing standards.
- The allowable warpage of the tile modules.
- The spacing or separation of each tile module, which would influence a gradual or abrupt change in elevation.
- Angle of natural or manufactured light accentuating otherwise acceptable variance in modules.
- Highly reflective surfaces of tile modules accentuating otherwise acceptable variance in modules.
In addition, variations in the plane of the substrate will also affect lippage. In many cases, when tile is installed with thinset over an uneven substrate, the installed surface will not meet lippage standards.
Now that we know what lippage is and why it is important for tile to have little variation in height from one tile to the next we must understand the exact laws of allowance.
ALLOWABLE WARPAGE OF A TILE
The ANSI standard defines allowed warpage according to the type of tile. For a paver tile (commonly used on floors) the allowable warpage is defined as follows:
The warpage of each tile in the sample shall not exceed 1.0 percent along any edge nor 0.75 percent on either diagonal. From this formula the allowable warpage can be determined.
There is a common misconception that the allowable lippage on an installation is simply calculated from the allowable lippage of the table plus the allowable warpage of each tile. This is not correct.
American National Standards Specifications for the Installation of Tile
Tile Type |
Tile Size |
Joint Width |
Allowable Lippage |
Glazes Wall/ Mosaics |
1”x1” to 6”x6” |
1/8” or less |
1/32” |
Quarry |
6”x6” to 8”x8” |
1/4” or greater |
1/16” |
Paver |
All |
1/8” to 1/4” |
1/32” |
Paver |
All |
1/4” or greater |
1/16” |
ALLOWABLE WARPAGE ON AN INSTALLATION
The amount of allowable tile warpage is not used in the calculation of allowable lippage. Rather, allowable lippage is the total of the actual tile warpage and the allowable lippage from the table. Of course, the actual warpage should not exceed the allowable warpage as calculated above.
The reasoning of the standard is to define reasonable lippage from one tile to another. When a single tile is warped but within standards, all of the corners cannot be set in the plane of the adjoining tiles. Therefore, the tolerance for variation from tile to tile includes the actual warpage of the tile. If there is no warpage, the lippage should not exceed the value in the table.